LOADER REMOVAL 7-3
Remove the latch pin while move the control lever back
and forth slightly to make the latch pin easy.
120O702A
(1) Latch Pin
Pull the control lever to raise the loader until the inner
bearing box.
Adjust the bucket until the bottom surface of bucket touch
the ground.
Move the tractor backword slowly and stop to avoid the
hydraulic hoses being tighten.
Stop the engine and move the control lever back and
forth, left and right several times to reduce the hydraulic
pressure in the hoses.
Disconnect the quick couplers on the hydraulic hoses.
120O703A
To Next Page
Loading...
