Kioti LK30 - Page 95

10 - 9
PERIODIC SERVICE
10 - 8
LK30 / LK35
10 - 9
PERIODIC SERVICE
10 - 8
LK30 / LK35
1. Place the oil pan under the engine.
2.Removetheoillter.
3.Putalmofcleanengineoilonthe
rubbersealofthenewlter.
4.Tightenthelterquicklyuntilitcon-
tacts the mounting surface.
 Tightenlter,byhand,anaddition-
al half turn only.
5.Afterthenewlterhasbeenreplaced,
the engine oil normally decreases a
little. Make sure that the engine oil
does not leak through the seal and
be sure to check the oil level on the
dipstick. Replenish the engine oil up
to the prescribed level if necessary.
ADJUSTING BRAKE PEDAL
1. Release the parking brake
2. Slightly depress the pedals and
measure the free travel at the top
of the pedal stroke.
3. When adjustments are needed,
loosen the locking nut and turn the
turnbuckle until the rod length is at
the desired and acceptable limit.
4. Re-tighten the lock nuts.
(1) Brake Rod (2) Lock Nut
(A) Free Travel
S41OA12A
Proper
brake pedal
free travel
(A)
20 ~ 30 mm
(0.787 ~ 1.181 in.)
on the pedal.
Keep the free travel in
the right and left brake
pedals equal.
To avoid personal injury:

Be sure to stop the engine
before changing oil lter car-
tridge.

Allow engine to cool down
sufficiently, oil can be hot
and can burn.
CAUTION
To avoid personal injury:

Stop the engine and chock
the wheels before checking
brake pedal.
CAUTION
LK35-AU-10.indd 9 2010-01-20 오후 3:19:30