Kioti LK30 - Page 96

10 - 11
PERIODIC SERVICE
10 - 10
LK30 / LK35
10 - 11
PERIODIC SERVICE
10 - 10
LK30 / LK35
REPLACING HYDRAULIC OIL
FILTER
1. Place the oil pan under the hydrau-
licoillter.
2.Removetheoillter.
3.Placealmofcleantransmission
uidtotherubbersealofthenew
lter.
7.Makesurethatthetransmissionu
-
id doesn’t leak through the seal.
(1) Hydraulic Oil Filter
S41OA13A
4.Tightenthelterrmlyuntilitcon-
tacts the mounting surface. Then
tightenthelter,byhand,anaddi-
tional half turn only.
5.Afterthenewlterisinplace,llthe
transmission up with oil to the up-
per line of the oil gauge.
6. After running the engine for a few
minutes, stop it and check the oil
level again, add oil to the prescribed
level.
(1) Oil Inlet Plug (2) Gauge
(A) Oil level is acceptable within this range
S41OA14A
To avoid personal injury:

Be sure to stop the engine
before changing oil lter car-
tridge.
CAUTION

To prevent serious damage
to the hydraulic system, use
only a genuine KIOTI lter.
IMPORTANT
LK35-AU-10.indd 10 2010-01-20 오후 3:19:31