(1) Drain Plugs
1. To drain the used oil, remove the
drain plugs at the bottom of the
transmission case and differentials.
Drain the oil completely into a drain
pan.
2. After draining reinstall the drain
plug.
3.Fillwiththenewuidtotheupper
line of the gauge.
(See “LUBRICANTS” in Mainte-
nance Section)
4. After running the engine for a few
minutes, stop it and check the oil
level again; add oil to prescribed
level.
5. Check drain plugs for leaking
CHANGING TRANSMISSION
FLUID
S41OA15A S41OA16A
(1) Oil Inlet Plug (2) Gauge
(A) Oil level is acceptable within this range
Do not operate the tractor
immediately after changing the
transmission fluid.
Run the engine at medium speed
for a few minutes to prevent
damage to the transmission.
IMPORTANT
To avoid personal injury:
Allow engine to cool down suf-
-ciently, oil can be hot and can
burn.
CAUTION
Oil capacity
Model
LK30
26.0 (6.87 U.S gals.)
LK35
24 (6.34 U.S gals.)