Kioti RX6030 - Removal and Installation of 3-Point Hitch Implement

6
-
2
RX6030 / RX7030 / RX8030
REMOVAL AND INSTALLATION OF 3-POINT HITCH IMPLEMENT (WITH PTO SHAFT)
1. Drive the tractor backwards to
move close to an implement (ap-
pro x. 5 cm) . The n, adj ust th e
height of the lower link to be paral-
lel to the pins of the implement.
2. Put all the shift levers in the neu-
tral position, stop the engine, and
apply the parking brake.
H11O562A
(1) Implement Support (1) Telescopic Stabilizers Pin
H11O567A
3. Remove both of the Telescopic
Stabilizers xing pins.

When removing/installing an
implement, remove the check
link pin to use the lower link
end (cassette type) effectively.
(1) Latch (2) Lower Link End
H11O564A
4. Press the latch to pull out the low-
er link end. (Cassette type)
IMPORTANT
TF120(RX6030,7030,8030)-AU-06.in2 2 2015-10-29 오후 2:26:30