To avoid accident:
Engage the switch only when
the vehicle is stationary.
While the 4WD is engaged,
dr iv e t he v eh ic le wit h low
speed as steering and braking
characteristics may differ.
It is possible to engage the
4WD during driving. However,
you may hear noise or feel
slight shift or impact at times
in this case. For safe driving,
engage the 4WD when the trac-
tor is stationary.
The 4WD should not be used
on a paved road as tires can
be worn faster and could cause
damage to front axle.
CAUTION
3. When working on a sandy surface
4. When the tractor is pushed out by
reaction from the implement during
cultivating on a hard surface.
5. When cultivating a eld or driving
over a bank
1. To activate the quick-turn function,
press the switch downward.
2. When operating the switch to acti
-
vate the quick-turn function, make
sure that the front wheels are in
the straight ahead position.
HOW TO USE QUICK-TURN FUNCTION
Be sure to select the 2WD dur-
ing driving, as 4WD or quick-
turn can cause an unexpected
accident during driving.
Never make a sharp turn dur-
ing driving.
If your work requires mid to
high load applied to the front
loader or four wheels, using
the quick-turn function can
damage the quick-turn clutch
disc or wear it prematurely.
Therefore, never use the quick-
turn function under this condi-
tion.
•
•
•
CAUTION
The quick-turn function is use-
ful when working with a rotary
in field. However, be cautious
during its use as its misuse
can cause rollover. Never use
this function during driving.
Also, never use it on a steep
slope and sharp corner.
A s a s a f et y m e as ur e , t h e
quick-turn function cannot be
activated when the range shift
lever is set to the high speed
position and the vehicle speed
is over 6 km/h.
Make sure to set the switch to
the 2WD or 4WD position be-
fore leaving the eld.
•
•
•
CAUTION
To Next Page
Loading...
