Kipor ID6000 - Pre-Operation Check; Check Engine Oil Level

Be sure to check the generator on a level surface with the
engine stopped
1. Check the engine oil level
Using nondetergent oil or 2-stroke engine oil could shorten
the engine's service life.
Use a high-detergent, premium quality 4-stroke engine oil. certified to meet CC or CD
grade SAE10W-30 oil is recommended.
Select the appropriate viscosity of oil according to the ambient temperature.
SAE Viscosity grade table
Open the left door, Loose the cap and wipe the dipstick with a clean rag. Check the oil
level by inserting the dipstick in the filler hole after fastened.
If the oil level is below the end of the dipstick, refill the recommended oil up to the top of
the oil filler neck.
Running the engine with insufficient oil can cause serious
engine damage.
The Low Oil Alarm System will automatically stop the
engine before the oil level falls below the safe limit. However,
to avoid the inconvenience of an unexpected shutdown, it is
still advisable to visually inspect the oil level regularly
--
SAE20 20W
-30 -25 -20 -15 -10 -5 0 5 10 15 20 25 30
SAE
40
50
SAE10W
SAE30
SAE10W/30
SAE15W/40
SAE5W/20
SAE5W/30
--
4. PRE-OPERATION CHECK
Multi grade
Viscosity---Ambient temperature
Single grade
Ambient
temperature
a. Open the left door, loose the hoop and remove the diesel filter
b. Replace the diesel filter
c. Reinstall the filter element. Fix the hoop and close the left door.
4. Pump maintenance:
Do not dismantle the pump randomly. Please contact KIPOR dealer if special tools are
required for pump replace and clean.
5. Battery maintenance
a. Unscrew the bolts on cover plate, remove the cover plate
b. Remove the fixing belt
c. Replace the battery and fasten the fixing belt, install the cover plate, fasten the bolts
and close the side door.
1. battery maintenance
cover plate
2. battery fixing belt
3. battery
Air filter sticker
Genset code
Battery maintenance sticker
WARNING
WARNING
WARNING
CAUTION