- 13 -
• Internet Settings
Local IP：repeater IP address, such as 192.168.1.100.
Subnet Mask: the repeater subnet mask in local area network, such as 255.255.255.0.
Gateway: the repeater gateway in the local area network, such as 192.168.1.1.
DNS：configure the domain name server or set it as 0.0.0.0.
Networking Modes: supports three modes including: no network, as server or as slave device. When it is
used as server, the local monitor port should be configured and the slave device is connected to system
network through this port. When it is used as slave device, the serve IP(or domain name) and port
should be configured.
Network Time Slot Configuration: both two time slots can be equipped with or without network. In case of
network status, the internet time slot ID should be configured. When the repeater is networked, it will
determine whether it should transmit data according to network time slot ID. It transmits data when the
ID is different while it does not transmit data if the ID is different.
Indicator Setting: in the networked status, the repeater will transmit signals regularly according to
indicator settings, so that the portable radios can perform roaming according to signals. The time interval
to activate the repeater is ranged from 10 seconds to 600 seconds; 30 seconds by default. The continual
time to activate the repeater is ranged from 200 milliseconds to 7000 milliseconds, 1000 milliseconds by
default.
Encryption Setting: encryption is optional. The password is set to be 10 hexadecimal characters, such as:
8A4428331D.
To Next Page
Loading...
Need help?
General
