68
Troubleshooting
Sr. Problem Probable cause Action
No
1. Leakage through cleaner Rectangular rubber ring damage Change rubber ring.
2. Rotor does not rotate Nozzles blocked Open rotor and clean nozzles
Thoroughly.
Re-assemble the cleaner.
3. Rotor does not rotate even Entry valve blocked Do not open entry valve assembly.
after cleaning nozzles It requires special tools Contact
your Distributor.
4. Rotor rotates but at low Leakage of oil through rotor Open rotor and ensure that the
Speed assembly. rubber ring has taken proper seat
on rotor body. Then re-assemble
the rotor.
Rotor filled with dirt completely Time for cleaning the rotor
5. Rotor speed very low Bushes damaged permanently Ensure that the rotor is free on
or even rotor does not Shaft. Else replace entire rotor
rotate Assembly.
6. Abnormal vibrations of Mismatch between arrow Open rotor and reassemble it
centrifuge cleaner marks on rotor cover and rotor properly.
7. Cleaner does not collect Rotor not rotating at desired See point 2 & 3.
any dirt speed Consult your Distributor.
Consult your Distributor in case of any doubt.