4 Transport and decommissioning
4.1 Unit transport
On delivery, the unit is transported after consultation with the spe-
cialist dealer.
When transporting the unit during a change of location while the
unit is still operating, observe the following safety instructions.
WARNING!
Danger of crushing injuries from falling unit!
If the unit is tilted, it will fall over in an uncontrolled
fashion. When the unit falls over, there is a danger of
crushing to the hands and feet.
– Wear safety shoes and safety gloves when trans-
porting the unit.
– Transport the unit in an upright position.
WARNING!
Danger due to escaping refrigerant!
The refrigerant used in the unit is explosive and pres-
surised, and can cause serious injury if it comes into
contact with the eyes or skin.
– During transport and set-up, do not bend or pierce
the tubing and the evaporator.
– Do not damage the surface coat (scratching it off,
for example).
– Wear safety glasses and protective gloves when
handling the refrigerant circuit.
NOTICE!
Danger of damage to the melt water container!
The units in the table below are equipped with a melt
water container on their underside, which can be dam-
aged by incorrect transport:
– Place unit on pallet and transport it.
– Do not lift unit with forklift or pallet truck unless it is
on a pallet.
MED 520 PRO-ACTIVE MED 520 ULTIMATE
MED 520 CR PRO-ACTIVE MED 520 CR ULTIMATE
MED 720 PRO-ACTIVE MED 720 ULTIMATE
Safety during transport
Transport and decommissioning
Unit transport
23.05.2023Refrigerator/freezer MED series32
To Next Page
Loading...
