What to do if my Kisae Inverter products connected to unit malfunction or overheat?
If the products connected to your Kisae Inverter malfunction or overheat, it might be because they are not compatible with the Modified Sinewave output generated by the inverter. Check section 4, “AC Load on Inverter” for compatibility information.
What to do if Kisae 3000W - 120V has no AC output and the status LED is Green?
If your Kisae Inverter has no AC output and the status LED is green, the circuit breaker may have tripped. Check the load and reset the related circuit breakers located by the side of the unit and the AC output front panel.
What to do if Kisae 3000W - 120V has no Output and the Status LED is in Red?
If your Kisae Inverter has no output and the status LED is red, the circuit breaker might have tripped. Check the load, reset the related circuit breakers, verify the error condition, and make corrections.
What to do if there is no power to my Kisae 3000W - 120V?
If there is no power to your Kisae Inverter, check the DC fuse and disconnect switch.
Crucial safety guidelines and warnings for operating the inverter.
Instructions for physically mounting and securing the inverter unit.
Critical steps for properly grounding the inverter chassis for safety.
Step-by-step guide for connecting the DC power input to the inverter.
Procedures for connecting AC loads to the inverter's output ports.
Lists error codes and their corresponding corrective actions.
General| Model | Kisae 3000W - 120V |
|---|---|
| Power Output | 3000W |
| Continuous Power | 3000W |
| Output Voltage | 120V |
| Waveform | Pure Sine Wave |
| Peak Power | 6000W |
| Cooling Method | Temperature Controlled Fan |
| Input Voltage | 12V DC |
| Efficiency | 90% |
| Input Voltage Range | 10.5V - 15V |
| Protection Features | Overload, Short Circuit |
To Next Page
