13
English
USING THE WATER KETTLE CARE AND CLEANING
Cleaning the Water Kettle and base
IMPORTANT: Before cleaning, always
disconnect the Water Kettle from electrical
outlet and make sure that the Water Kettle
has cooled completely.
Calcium deposits may form on the interior
metal parts of the Water Kettle. To get the
best performance from your Water Kettle,
clean periodically. The cleaning interval
will depend on the hardness of the water
you put into the Water Kettle. The use of
a commercial descaler is recommended.
MIN
0.5L
0.75 L
1.0L
1.25 L
1.5 L
White
vinegar
Water
Wash Water Kettle and base by hand with a
damp cloth. Dry and polish with a soft cloth.
Abrasives and scouring agents of any kind
are not recommended.
Descaling the Water Kettle
If a commercial descaler is not available:
1. Fill the Water Kettle with white vinegar
to the MIN (0.25 L) mark.
2. Add water to the 0.75 L mark.
3. Boil and allow to stand overnight.
4. Empty the solution from the
Water Kettle.
5. Fill the Water Kettle with water, bring
to a boil and drain out the water. Repeat
this step twice. The Water Kettle is now
ready to use.
Cleaning the lter
NOTE: If calcium deposits remain on the
lter, let it stand overnight in a solution
of water and white vinegar. Rinse the
lter thoroughly and place back in the
Water Kettle.
Remove lter from Water Kettle (see
“Inserting and removing the lter”),
then rinse under running water.
W10530534D_01_ENv07.indd 13 2/29/16 11:35 AM
To Next Page
Loading...
