9
PRODUCT USAGE
INSTALLING THE REVERSIBLE SLICING/SHREDDING DISC OR
SLICING BLADE
1
To slice: Turn the disc so that the
raised Slicing Blade is facing up.
To shred: Turn the disc so that the
small, raised Shredding Blades are
facing up.
The disc can be placed in two different
positions: high at the top of the bowl
for processing, and low in the bowl for
storage.
NOTE: While the disc will operate in
storage position, it will not perform as
well. Make sure the disc is level with the
top of the bowl for best performance.
2
Hold the disc by its centre hub and
lower it onto the Drive Adapter,
aligning the marks on the centre
hub of the disc to the marks on the
adapter. The disc should be level with
the top of the bowl. If the disc falls to
the storage position, lift it out, turn it
90°, and lower it again.
3
Install the Work Bowl cover, making
sure the Lid Latch is pushed down to
the locked position.
Process
Storage
Alignment
marks
W11501509A_01_EN.indd 9W11501509A_01_EN.indd 9 30-12-2020 13:29:0430-12-2020 13:29:04
To Next Page
Loading...
Need help?
General
