10
CONTROLS AND CYCLE STATUS
Control Purpose Comments
To start or resume
a wash cycle.
If the door is opened during a cycle or the power is interrupted, the
Start/Resume indicator ashes.
NOTE: Push door rmly closed within 4 seconds of touching Start/
Resume. If the door is not closed within 4 seconds, the Start/Resume
keypad LED will ash, an audible tone will be heard, and the cycle will
not start.
To reset any cycle
or options during
selection.
To cancel a wash
cycle after it has
been started
Touch and hold CANCEL/DRAIN to reset any control selections made.
To turn the
audible tones
on or off.
Touch and hold HI-TEMP WASH for 3 seconds to turn the audible tones
on or off. Only audible tones for conrming keypad touches can be
turned on/off. Important audible tones, such as indicating a cycle has
been interrupted, cannot be deactivated.
To follow the
progress of the
dishwasher cycle
and to indicate
the success of the
Sani Rinse.
If you select the Sani Rinse option, when the cycle is nished, the
Sanitized indicator on the control panel glows. If your dishwasher did
not properly sanitize your dishes, the Sanitized indicator ashes at the
end of the cycle. This can happen if the cycle is interrupted or if water
could not be heated to required temperature.
The light goes off when you open and close door or touch
CANCEL/DRAIN.
Canceling a Cycle
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop before completely opening the door.
2. Press and hold CANCEL/DRAIN once. The Cancel/Drain light
will light up.
3. Close the door and the dishwasher starts a drain cycle (if
water remains in bottom of dishwasher). Let the dishwasher
drain completely. The Cancel/Drain light turns off after
2 minutes.
Changing a Cycle After Dishwasher Is Started
You can interrupt a cycle and restart your dishwasher from the
beginning using the following procedure:
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop, then open the door completely.
2. Check that detergent dispenser cover is still closed. If cover
is open, you will need to rell the detergent dispenser before
restarting your new cycle.
3. Press CANCEL/DRAIN and wait approximately 2 minutes until
the machine drains and the Cancel/Drain light turns off.
4. Select new cycles and options.
5. Press START/RESUME.
Adding a Dish After Dishwasher Is Started
1. Open the door slightly to stop the cycle. Wait for the spraying
action to stop and then completely open the door.
2. If the detergent dispenser door is closed you may add a dish.
If the detergent dispenser door is already opened an added
dish might not be cleaned.
3. Press START/RESUME and close the door. If the door is not
closed within 4 seconds, you will hear a series of beeps and
the dishwasher will not start.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
