KitchenAid KDTE104DSS0 Installation Instructions

Option B, Install Access Panel - Metal Panel
Check that grounding clip is attached to the lower panel. Position
the lower panel behind the access panel. On some models there
is insulation on the access panel that must fall behind the
insulation on the lower panel.
Hold the 2 panels together and place them against dishwasher
leg. Using a Phillips or 1/4"screwdriver, reinstall the screws through
the holes in the access panel and the slots in the lower panel.
Check that the lower edge of the lower panel contacts the floor.
Adjust if necessary.
Tighten access panel screws.
25

KitchenAid KDTE104DSS0 Specifications

General

Style	built-in dishwashers
Color	stainless-steel
Noise level	46 decibels
Control Type	electronic
Delay Start	yes
Child Lock	no
Load Sensor	yes
Number of Racks	2
Cycle Signal	no
Water Filter	yes
Food Disposer	no
Sanitize Settings	no
Annual Energy Consumption	260 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	24.75 inches