Lower jets clean pans, casseroles, etc., with
tough food soil to eliminate the need for
soaking and scrubbing of dirty, baked-on
dishes.
Tough
Normal
ProWash™
Top Rack
Only
Activates the
ProScrub
®
spray jets
to provide intensified
cleaning power to
specific wash areas.
75 90 0 - 1.5
(0 - 5.7)
Raises the main wash temperature to
improve cleaning for loads containing tough,
baked-on food.
Tough
Normal
ProWash™
Raises the main
wash temperate
from 105°F (41°C) to
either 130°F (55°C)
or 140°F (60°C).
40 50 0 - 1.5
(0 - 5.7)
Sanitizes dishes and glassware in
accordance with NSF International NSF/
ANSI Standard 184 for Residential
Dishwashers. Certified residential
dishwashers are not intended for licensed
food establishments. The Sani indicator
indicates at the end of the cycle whether the
Sani Rinse option was successfully
completed. If the indicator is not activated, it
is probably due to the cycle being
interrupted.
Tough
Normal
ProWash™
Increases the main
wash temperature
from 105°F (41°C) to
140°F (60°C) and
the final rinse from
140°F (60°C) to
155°F (68°C).
72 85 0 - 1.5
(0 - 5.7)
For added convenience, use for washing a
small load of dishes in the top rack to help
keep the kitchen continuously clean.
Available
with any
cycle
Slightly faster wash
for smaller loads
- 3 -40 0
Runs the dishwasher at a later time or during
off-peak electrical hours. Select a wash cycle
and options. Press the Delay button. Press
START/RESUME. Close the door firmly.
NOTE: Anytime the door is opened (such as,
to add a dish), the Start/Resume button must
be pressed again to resume the delay
countdown.
Available
with any
cycle
Delays the start of a
cycle to the
specified time
.
240 480 0
OPTIONS WHAT IT DOES
Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold TOP RACK ONLY for 3 seconds. The Control Lock light will stay on for a short time, indicating that
it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The
dishwasher door can still be opened/closed while the controls are locked.
NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL/DRAIN, or by opening and closing
the door before you are able to turn Control Lock off.
To turn off Control Lock, press and hold TOP RACK ONLY for 3 seconds. The light turns off.
NOTE: If your model requires you to press and hold TOP RACK ONLY to lock the controls, the Control Lock LED will be on or off
to indicate whether Control Lock is active or not.
Control Purpose Comments
To start or resume a
wash cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator
flashes. The cycle will not resume until the door is closed and START/RESUME is pressed.
NOTE: If the Start/Resume button is located on top of door, push door firmly closed within
3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the Start/
Resume button LED will flash, an audible tone will be heard, and the cycle will not start.
OPTIONS CAN BE
SELECTED
WITH
WHAT IT DOES ADDED TIME TO CYCLE ADDED
WATER
GALLONS
(LITERS)
TYPICAL MAX
To Next Page
Loading...
Need help?
General
