Auto-ResetMotor Protection
If thestandmixerstopsdueto
overload,slidethespeedcontrol
leverto OFF.Afterafewminutes,
thestandmixerwill automatically
reset.SlidetheSpeedControlLever
tothedesiredspeedandcontinue
mixing.
Using the Pou
Attaching the Pouring Shield*
1. Make sure the speed control lever
is set to the OFF/0 position.
2. Unplug the stand mixer.
3. Attach desired accessory and raise
the mixing bowl.
4. Slide pouring shield collar around
beater shaft, centering collar over
rim of bowl.
Using the Pouring Shield
Pour ingredients into the mixing
bowl through the chute portion of
shield.
IMPORTANT: Make sure the guides
on the bottom of the chute rest on
the rim of the bowl to keep
ingredients from falling outside the
bowl as they are added.
If the stand mixer does not restart,
see the "Troubleshooting Problems"
section.
ring Shield*
Pouring
Chute
Removing the Pouring Shield
1. Make sure the speed control lever
is set to the OFF/0 position.
2. Unplug the stand mixer.
3. Remove pouring chute from collar.
4. Slide pouring shield collar off
bowl.
5. Lower the bowl support by
turning the bowl-lift lever
clockwise.
6. Remove accessory and the mixing
bowl.
Cleaning the Pouring Shield
Wash in warm sudsy water. If you
wish, you may place on the top rack
of your dishwasher.
*If Pouring Shield is included.
10
To Next Page
Loading...
