KitchenAid KFP0922CU User Manual

11
English
Setting Up Your Food Processor
Attaching the Work Bowl
3. Grasp the work bowl handle and turn
the bowl counterclockwise to lock it
on the base.
Select the accessory you would like to use
and install it according to the instructions
on the following pages.
Attaching the Work
Bowl Cover
NOTE: Be sure to install the desired
accessory before attaching the work
bowl cover.
1. Place the work bowl cover on the work
bowl with the feed tube just to the left
of the work bowl handle. Grasp the feed
tube and turn the cover to the right until
it locks into place.
1. Place the Food Processor on a dry,
level countertop with the controls
facing forward. Do not plug in the Food
Processor until it is completely assembled.
2. Place the work bowl on the base, aligning
the raised portion with the indentation on
the base. The center hole should t over
the power shaft.
NOTE: Your Food Processor will not
operate unless the work bowl and work
bowl cover are properly locked on the
base, and the large pusher is inserted to
the maximum ll line on the feed tube
(approximately halfway down).
Power Shaft
Food
Pusher
2. Fit the food pusher into the 3-in-1
feed tube. See “Using the 3-in-1 Feed
Tube” for details on working with
different sized foods.
W10407578A_ENv2_bk.indd 11 7/1/11 5:45 PM

KitchenAid KFP0922CU Specifications

General

Brand	KitchenAid
Model	KFP0922CU
Category	Food Processor
Language	English