3.Connect water supplyline from
saddle valveto spoutcoppertubingwith
the factory-assembled quick-connect
fitting. Push water supplyline tubing
straightintofittingas far as it willgo. Pull
on tubing.
The tubing shouldnot come outwhen
properly installed.Turnthe saddlevalve
handlecountemlockwise_ toopen
water line.
NOTE: Do NOT plug powersupplycord intooutlet.
4.TurnTemperatureControl
counterclockwiseto"Off" position.
5 • Pushdown and turn the
On/Off Cap clockwiseto open spout.
Hold cap opento fill tank (about1
minute).When tank is full, water will
flow fromspout. Release cap.
6.Plug power supplycord into
groundedoutlet.
TurnTemperatureControlclockwise
to highestposition.
Water in tankwill reach maximum
temperature in approximately
15 minutes.
When water is heating,you may hear
gurglingnoisescomingfrom thetank.
There may also be some spittingor
hot water flow from the faucet. This is
normal for the initial heat-up ofthe
dispenser.
TurnTemperatureControlto lower
temperaturesettingifyou notice
vaporor hear boilingnoise.
NOTE; Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwiseto
lowerwatertemperature.
To Next Page
Loading...
