NOTE:DoNOTplugpower supplycord intooutlet.
a mConnect 1/4" (6.4 mm) spout
tubing (longer tubing) to the rear
quick-connect fitting on top of tank.
Push tubing straightinto fitting as far
as it will go, Pull on tubing. The
tubing should not come out when
properly installed,
Do Not lengthen, twist or tightly
bend tubing.
=Connect clear tubingfrom spout
to center tanktubing usingclamp.
Make sure clear tubingdoes not kink.
0 • Install saddle valve following
kit instructions.If water supplyline is
not copper,shut off water supplyand
drain line. Drilla 1/4" (6.4 ram) hole
into water supplyline for the saddle
valve piercingpin.
1 .Turn saddlevalve handle
clockwiseN until lance pierces soft
coppertubingand valveis firmly
seated. Ifthe water lineis notcopper,
turnthe saddle valvehandle
clockwiseuntilthe valve is firmly
seated.The valveis now inthe
closedposition.
Placea bucketunderopen end of
water supplyline.Turnon main water
supplyvalveto pressurizecoldwater
line.Check for leaks.
1 2=s ow yo_n saddle valveand
flush line intobucket to remove any
foreign materialthat may have been
trapped inthe supplyline during
saddlevalve installation.
Closesaddle valve.
To Next Page
Loading...
