KitchenAid KSRB22Q - Installing the Refrigerator

INSTALLING THE REFRIGERATOR / y
Installing the Refrigerator
In This Section
Page
Page
Cleaning the refrigerator.
..6
Locating the refrigerator properly ..
.6
Plugging In the refrigerator.
.5
Leveling the refrigerator.
.6
If you want your refrigerator to work properly, you need to install It properly. This section tells you
all you need to know to install your refrigerator.
Cleaning the refrigerator
Clean your refrigerator before using It, If nec¬
essary. See cleaning Instructions on pages
21 and 22.
Remove the Consumer Buy Guide Label
and any shipping tape before using the
refrigerator.
To remove any remaining glue:
• Rub briskly with your thumb to make a ball,
then remove.
OR
• Soak area with liquid dishwashing detergent
before removing glue as described above.
IMPORTANT: DO NOT USE sharp instruments,
rubbing alcohol, flammable fluids or abrasive
cleaners. These can damage the material.
See 'Important Safety Instructions' on page 3.
DO NOT REMOVE the Tech Sheet fastened
under the refrigerator, behind the base grille.
Plugging in the refrigerator
A 115 Volt, 60 Hz., AC only, 15 or 20 amp
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit, serving only this appliance,
be provided.
Do not use an extension cord. Use a
receptacle which cannot be turned off with
a switch or pull chain. See Electrical
Requirements and Grounding Instructions
Sheet in your Literature Package.
3-prong grounding
type wall receptacle
Recommended grounding method
5