1. Pull out drawer rails.
4. Recheck left to right level by placing the level on the top of
the drawer.
2. Set draweronto rails.
3. Pull rails forward until they snap into position.
5. Slide the dishwasher into position in the cabinet opening.
Check to ensure that the drain hose and electrical wiring are
not kinked.
6. In the cabinet under the sink, coil excess drain hose and wrap
with a zip tie. Plug in dishwasher or reconnect the power.
/
7. Select the Rinse Only cycle and press START/RESUME.
Allow the dishwasher to fill, rinse and drain. Check for leaks.
If leaks are found, secure the connection and repeat this step.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the User
Instructions or contact the dealer from whom you purchased your
dishwasher.
14
To Next Page
Loading...
