EasyManua.ls Logo

KitchenAid KUDE20IXSS9 - Installation Requirements; Tools and Parts List; Additional Installation Supplies; Useful Installation Items

KitchenAid KUDE20IXSS9
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
INSTALLATION
REQUIREMENTS
_, v ' .. _ ....
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Pliers
Phillips
screwdriver
5/16"and %"
nut drivers or
hex sockets
Measuring tapeor ruler
10" adjustable wrench
tha! opens to _
1V8 (2.9 cm)
Flat-blade
screwdriver
Utility knife
UL Listed/CSA
Approved twist-on _ _
wire connectors*
Small level
%" open-end
wrench
If installing custom front panels, ../t-_/
Torx ®*T15 screwdriver
Must be the proper size to connect your household wiring to
16-gauge wiring in dishwasher.
Other useful items you may need:
" oth,owe
Parts supplied:
Drain hose
damps (2)
(1 large and
Silver Green
Drain hose #10 X _/2" 2 C Unde[ _
Phillips, COunter
I head mounting
Parts needed:
%, Compr X¾', hose fitting
For part or kkl see local
retailer or call Whiflp0ol
Parts: !-800:442.9991, Part
Num ber W 10273460
4 #10 x V2" wood screws (if installing custom front panels)
Supplied in Kit:
4 Plastic studs (attached to each other by runners)
4 Short screws (10-16 hex head screw)
4 Long screws (8-18 Torx®t) head screws)
1 Template (located inside Use and Care Guide bag assembly)
1 Instruction sheet (located inside Use and Care Guide bag
assembly)
NOTE: The screws supplied are used for only 3/4"thick wooden
panel. If the wooden panel is less than 3/4"thick, customer must
purchase screws locally.
Other parts you may also need:
I I
1 .2 Masking or I Molsture _J
(3'81-5 Cm)I duct tape [ barrier tape _[
ScreW4ype I (Part aumber.r/_/ [
Clamps (3 maX!mum) J [4396277)_1
NOTES:
Moisture barrier tape is recommended when installing a
dishwasher under a wood countertop.
Parts available for purchase in plumbing supply stores. Check
local codes. Check existing electrical supply. See "Electrical
Requirements" section. It is recommended that electrical
connections be made by a licensed electrical installer.
In addition, for first-time installations
Toolsneeded:
Parts needed:
i
' " ReqUirements" Sec ion:Copper tubing (%' See Electrical t
O.D'Suggested) or ..... : _ .. .. .
flexible braided _or ulrect vwre: _-or r'ower bupp!y
water su L..,. ne Use UL Listed/ Cold: use UL
CSA Appr0ved [ Listed/CSA
__X'_ strain relief [ Approved power
tttttL_ J)_,)))..) to fit% (2.2 cm)I sUPPlY c°rd kit
.... hole [ marked for use with
_//_ .... dishwasher ....
Additional parts supplied with top-venting models only:
Additional parts supplied with certain models only
[ Bottomsound
| flocated in lower rack) J
Make sure all these parts are included in the literature package.
If parts are not included, call 1-800-422-1230.
1-®TORX is a registered trademark of Saturn Fasteners, Inc.

Related product manuals