Care of Your Dishwasher
11
tqo(ka_' wl;ich would in turn prevent the db, h-
\va',tler lrc, m draining properly. ] he warranty pro-
',i<lrd ',_.ith the db, hwa'-;her doe< not (over service
c()_,t,-,dire(t[\ a'-,,,ociat_'d with ti_e (leaning or re
pair o{ thi'-. (,xternal device.
REMOVING
THE DISHWASHER RACKS
[)O NO10PI R*\TE [)ISttW_\St_FR \\/IItI(])L!I It I[
R,'\L K"; IN PI,&C[
C'\LITI(')N: Fully loaded racks may behea\vand
.-,h_4Jld be handled (,lrelt_lh' to avoid
dropping.
TO REMOVE UPPEr RACK Pull out rack all the
way. On ea(h ,-ide _{ rack. there i,, a hiue bumper
with ,I plaqi< _,_1_ (.\_ v,,'hi_.h gnap'_ into a h,:fle at
the l()l) or tht, r,l( k Ira( k I'u,,h qnaF, from hole v,,'ith
a knih' hart(tie and lift (,lp Pull pin <Bt out of
bumper k(,rn<_\(' humpt'r'_ and roll _a,.k cmt of
tra( k
TO REPLACI UPPEr RACK Fit while roller', ()n
ea(h '-i(h' i>' ra_k int(+ h)\_.er _hannel,, _)f 1a(k
trm k_,. I<el)l,u €, !_umt>_'r', and i)in _, Pin mu,-,t ex-
tend thr()uq}: h(qe ,!I I)l)th_m ()f rack lra( k and
pia,,ti¢ (at) -.rS,ll)l)ed in h_qe _l_ t_l_ _1 ra(k track
TO REMOVE LOWER RACK R()II out rack and
lilt Ilom d(t(- TO REPLACE Pla_e ra(k on iden
FILTRATION SYSTEM
The water in vour dishwasher is being continuously
filtered by a three part filtration system. The outside
filter (C) and the inside filter (D not shown) work
simultaneously to trap food soils and prevent them
from recirculating and redepositing on dishes. These
filters should not need cleaning under normal use,
but if necessary, the outside filter can be easily lifted
out for cleaning TO REMOVE the outside filter, lift
D
F
/
\
E
lower wash arm straight up. Lift filter out. TO RE-
PLACE, clip outside filter over the inside filter and
then replace wash arm. When replacing wash arm,
be sure that water holes are facing up as shown in
photo. If the outside filter needs frequent cleaning,
or if there is foodsoil remaining on dishware, check
underside of washarm for blockage of the single
outside filter spray nozzle (G) or the nine inside filter
spray nozzles (H). Clean out with a toothpick.
G
H
The large object trap (E) collects bones, pits, or
other large items which may have mistakenly gotten
into the dishwasher. On occasion, check the trap
for such items. The large object trap may be easily
removed if necessary. TO REMOVE, lift trap out by
squeezing center section ([) and remove. TO RE-
PLACE, squeeze (:enter section so clips snap into
square notch.
Overflow Protection Float--The blue float (F) in
the front left corner of the dishwasher tank prevents
the dishwasher from overflowing. The float must be
in place for the dishwasher to operate.
* * -k -k
,\ small am(_unl l)l \V,/XIlR RI,M*\TNS 1N C,l_l\lP
(under filterl If) luhri(,_le se,fl
To Next Page
Loading...
