Kitchener 8 - Assembly and Operation Instructions; Before Use; Assembly Instructions; Grinding Instructions

4 of 8
• NEVER insert any foreign object into this appliance. Always use the accessories that were provided
with your unit.
• ALWAYS turn off and disconnect the appliance if it becomes jammed. Wait until the unit has come to
a complete stop before attempting to remove any jammed matter.
• NEVER force this appliance to operate beyond its designed rate. Trying to push the unit will only
result in problems. Practice safety and allow the unit to work properly.
• NEVER attempt to grind bones, cartilage or tendons. Make sure all metal matter (bullets, shot, etc.)
have been removed from all meat.
• ALWAYS allow all moving parts to come to a complete stop before using the reverse mode.
Reverse mode is designed to run for only a few seconds. Prolonged usage will result in damage to
the unit’s motor. Hitting the reverse mode while the unit is still running will also damage the motor.
• NEVER attempt to remove or attach the hopper tray, grinder head, locking cap or other accessories
while the appliance is in operation or plugged into the power outlet.
ASSEMBLY AND OPERATION INSTRUCTIONS
Before Use:
 Disassemble the grinder head and wash each part thoroughly in warm soapy water, removing all
food-grade packing grease and oil from the surfaces. Dry all parts before re-assembly.
 Keep packing material for future storage of grinder and grinder parts.
Assembly Instructions:
 Insert grinder head into gear housing; be sure that the hopper tray throat is facing upward. Holding
grinder head with one hand, place locking knob into the hole on the side of Motor housing and
tighten it clockwise (See Fig 1).
 Insert auger into the grinder head. You may need to turn the auger to align it with the drive shaft of
the motor (See Fig 2).
 Place cutting knife blade onto Feed Screw shaft of the auger with the Flat edge of blade facing the
front (See Fig 3).
 If blade is not seated properly, meat will not be ground.
 Place desired grinding plate next to Cutting Blade. The notch in the plate should align with the
protrusion on the grinder head (See Fig 4).
 Firmly screw ring cap onto grinder head. Do not over tighten (See Fig 5).
 Insert the Hopper meat tray onto the throat of the head (See Fig 6).
Grinding Instructions: