•
Place the refrigerator in the coolest and
best ventilated part of the room. Don't install
the refrigerator in the near of heat and direct
sunlight sources.
•
Remove the straps securing the cardboard packing
Remove the cardboard. Covering
Remove the PET protection film
•
Clean the refrigerator with mild detergent
and then dry it with a soft cloth.
8.
Connecting to the main powersupply
This operation must be carried out by
professionally and qualified persons.
The refrigerator are supplied complete with a
power supply cable for the connection to the
main power supply. A thermomagnetic circuit
breaker (not supplied) must be installed
between the mains power point and the power
supply cable of the refrigerator.
Before proceeding make sure that:
•
the mains voltage corresponds to the voltage on
the refrigerator 115V/60Hz/1Ph; to ensure proper
operation it is essential for the
power supply voltage to come within a
range of+/- 10% of the unit's rated voltage
To Next Page
Loading...