8
9
First time charging the battery
The unit has a built-in rechargeable lithium battery. Connect
the micro USB end of the USB power cable into the micro USB
charging port on the Cadet. Connect the other end to a PC USB
port or USB mains charger. The battery will start charging.
Note:
• It takes approx. 4 hours to fully charge the battery
• Whilst charging, the Power LED will pulsate red
• When fully charged, the Power LED will turn off
• A fully charged unit has up to 6 hours of playback time
• You can charge and play music at the same time
Pairing the speaker to your device
Before you can use the speaker via Bluetooth, it will need to be
paired to your device.
To do this:
1. Press and hold the Power/Mode button for 4 seconds and the
LED will slowly flash blue
2. Turn your device’s Bluetooth ON and search for new devices
3. When the ‘Cadet’ appears in the list, select it and if asked for
a pass code, enter ‘0000’
4. The Bluetooth LED will turn solid and you will hear a tone to
signify the speaker is connected to your device
To pair additional devices to the speaker, first make sure the
Bluetooth is turned off on any devices that have already been
paired to the speaker. Then follow the above instructions from
step 1.
To Next Page
Loading...
