16 17
Troubleshooting
No sound
• Either the audio cables are not connected or the speaker is not in the
correct mode
• Ensure that the cables are connected and use the remote control to
select the correct mode
• Ensure the audio output is set correctly on your devices
• With everything connected correctly, turn the Chorus off at the wall,
wait for 60 seconds then turn it back on
No power
• The Chorus is not connected to the mains power or the mains socket
is not switched on
Remote control not working
• The remote control is further than 8 metres from the unit
• The batteries in the remote control are flat and need replacing
No sound in Bluetooth mode
• A Bluetooth connection has not been established or there are no
video/audio files playing
• Ensure that Bluetooth is connected and press play on the video/
audio files
• Check that the volume is up on your device and the Chorus
Sound is distorted
• The volume is too high on your device
• There is an EQ on your device that is enabled
[...continued] Wall mounting
8. Ensure that all cables are connected to the Chorus
9. Attach the Chorus to the screws by sliding the brackets over the screws
5. Drill the dots using a 8 mm drill bit (depending on how soft/hard
your walls are)
6. Insert the dowels into the drilled holes
7. Screw both remaining screws into the dowels ensuring they are
protruding 5 mm from the wall (see image below)
5 mm
To Next Page
Loading...
