8 9
TWS for stereo sound
1. With both speakers turned on and in pairing mode, short press TWS button (1) on one speaker
(Master) and the LED indicator (6) will quickly ash red and blue
2. The Master speaker will automatically nd the other speaker
3. Once connected the LED indicator (6) will slowly ash purple on both speakers
4. Turn your iOS, Android, or Windows device’s Bluetooth ON and search for new devices
5. Select ‘KS Hive X’. If asked for a passcode, enter ‘0000’, and the device will pair
6. Once connected, the LED indicator (6) will be a solid purple if playing audio or slowly
ashing purple if not playing audio
Note: To cancel the TWS on both, long press TWS button (1) and they will disconnect and re-enter
pairing mode.
USB output
You can charge your device via the USB output (12), the output voltage and current is 5 V / 1 A.
• Please do not use the USB output (12) when the battery of KS Hive X is below 30% (when the Battery
LED (7) is ashing red every 3 seconds)
• It’s not available to use when powered o
Please note: Your device will have an internal amplier and if it is playing digital les like MP3s it will also
have an integrated DAC (Digital Audio Converter). If you turn the volume up to 100%, your device will be
sending a distorted signal. To avoid this, and to get the best quality from the speaker, we recommend
that you do not run your device any higher than 95% volume. Some devices output higher than others,
so you may need to reduce the volume if you experience distortion.
Care for your Hive X
Please DON’T:
• Submerge the Hive X speaker in water or spray water for over 3 minutes
• Drop the Hive X as this will invalidate your warranty.
• Open up the Hive X. There are no user serviceable parts inside
• Expose the Hive X to extreme temperatures or rapid changes of hot to cold or vice versa
Please DO:
• Clean the Hive X with a soft dry cloth and no detergents
To Next Page
Loading...
