EasyManua.ls Logo

Kitsound PocketDAB - Getting Started; Normal Mode; Choosing a Language; Instructions for Use

Kitsound PocketDAB
6 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 5
FM mode
1. Switch the radio on as explained in ‘Getting started’
2. Short press On/O (1) to change to FM Mode
Normal mode
1. Short press the MFB (7) until only the frequency is displayed like below
2. Short press Tune+ (5) or Tune– (6) to manually scan and choose your desired station,
or long press Tune+ (5) or Tune– (6) to automatically scan all available stations
3. To save a station, long press the MFB (7) for 2 seconds and a preset number will appear
on the LCD (11) depending on how many presets have been saved. For example P02 will
mean preset 2. A maximum of 32 stations can be saved
Instructions for use
Charging the PocketDAB
Give the PocketDAB a full charge before its rst use.
1. Connect the USB charging cable to the Micro USB charging port (10) and plug into power
2. The LCD (11) will show a battery icon whilst charging. The icon will be full once fully charged
Getting started
1. Long press On/O (1) to turn the radio on/o
2. Short press On/O (1) to change between FM and DAB+. The LCD (11) will show what
mode you are currently in
3. Plug in earphones into the 3.5 mm aux-in (3) before use. This will be used as an antenna
Choosing a language
Regardless of mode, when the radio is turned on, hold down the MFB (7) to go through the
languages. Release once on desired language.