8 9
Instructions for use
Powering the Revive
The Revive can be powered by either of the methods below:
Mains power:
• Connect the DC jack to the back of the Revive
• Plug the mains plug into a mains socket and switch on
• Slide the OFF/ON switch on the back of the Revive to the ON position
Battery power (4 x AA):
• Remove the battery cover on the Revive
• Insert the 4 x AA batteries observing the correct polarity
• Replace the battery cover
• Slide the OFF/ON switch on the back of the Revive to the ON position
Using the Revive
Once the Revive has been switched ON, press the mode button to switch between DAB and FM modes.
DAB radio mode
When DAB radio mode is activated for the first time, a full scan will automatically commence. Please make
sure the antenna is fully extended and the radio is positioned in a strong signal location. If no stations are
found, try re-positioning the radio and doing another channel scan by pressing the ‘Scan’ button.
Select stations
To change stations, press the ‘Next station’ or ‘Previous station’ button then press the ‘Enter’ button.
Adjust volume
Press the Vol – or Vol + buttons to decrease or increase the volume respectively.
[continued...]
To Next Page
Loading...
