7
• The lid of the kiln must not be used as a storage surface or
table, even if the kiln is not in use (the mechanical lid
should not be put under any pressure and in use the heat
given off could present a hazard, free heat radiation needs
to be guaranteed during operation).
• The kiln must never be opened during use or until the
firing chamber reaches a temperature of less than 50 °C.
The escaping hot air is a fire and health hazard.
• Never use extension leads to connect your kiln to the power
supply!
• During maintenance disconnect the kiln from the power
supply (pull the plug or if applicable turn off the isolator
switch).
• The whole electrical circuit must be checked by a service
engineer prior to first use of the kiln, after maintenance and
repairs and regularly at least every 4 years.
• Keep order in vicinity of the kiln. Disorder increases the risk
of accidents.
• Changes to electrical components may only be carried out
by qualified service engineers. Proceed only according to
circuit diagram!
• Safety devices must never be put out of operation.
If you are not able to properly carry out your work process
with our protective devices, please let us know. Together we
will surely find an acceptable solution.
To Next Page
Loading...