international 33
Trouble shooting
Fault Possible cause Solution
Motor does not start a) No power
b) Switch, Condenser
c) Electrical extension cord is defective
a) Check mains connection
b) Have them checked by an electrical
engineer
c) Remove the plug from the socket, check
it, and replace if necessary
Saw blade is not
running straight
a) Guide has been wrongly set
b) Wrong saw blade
a) Set the saw blade guide according to the
operating instructions
b) Select a saw blade according to the
operating instructions
Burn marks appear
on the wood during
the cutting work
a) Blunt saw blade
b) Wrong saw blade
a) Change the saw blade
b) Select a saw blade according to the
operating instructions
Saw blade jams
during cutting work
a) Blunt saw blade
b) Deposits on the saw blade
c) Guide has been set poorly
a) Change the saw blade
b) Clean the saw blade
c) Set the saw blade guide according to the
operating instructions
To Next Page
Loading...
