Need help?Do you have a question about the Kity 619 and is the answer not in the manual?
Details on noise levels during operation and idle.
Specifies dust emission levels and pressure.
Step-by-step guide for assembling the saw components.
Instructions for fitting the parallel guide and additional guide.
Instructions for fitting the guide for angled cuts.
How to adjust the blade height for desired cutting depth.
How to set the blade angle for bevel cuts.
Instructions for safely connecting the machine to the power supply.
Calibrating the zero point of the parallel guide.
Setting the parallel guide for desired cutting width.
Fine-tuning the parallel guide setting.
Setting the blade angle for angled cuts.
How to perform angled cuts using the guide.
Essential safety rules to follow during operation.
How to safely cut long pieces of wood.
Techniques for cutting narrow wood pieces.
How to perform rip cuts using a support and guide.
Using the angle guide for precise cuts between 45-90 degrees.
How to make precise 45° angle cuts for assembly.
Step-by-step guide to safely replace the saw blade.
Instructions for regular cleaning of the machine parts.
Common causes and checks for machine vibration.
Reasons for wood burning during cuts and solutions.
Causes of rapid blade wear and how to address them.
Troubleshooting for an overheating motor.
Reasons for the machine stopping and possible solutions.
Identifying and fixing issues causing wood kickback.
How to resolve difficulty in moving the sawing block.
Essential safety rules to follow during operation.
To Next Page
General
