Error Possible cause Remedy
Saw
Machine vibrates Clamping lever for height adjustment is not screwed tightly Tighten clamping lever
Tool is not screwed tightly Tighten tool
Unclean cuts / wood burns Tool is blunt Use sharp tools only
Tool is not installed correctly Check correct installation of the tool
Fast wear and tear of tool Tool is not sharpened correctly Have the tool re-sharpened correctly / install new tool
Covered wood (cement, sand, nails) Use clean wood only
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Different causes possible Get it checked by an electrician
Machine stops Feed is too fast Reduce feed
Tool is blunt Use sharp tools only
The wood is lifted high by the
rear part of the saw blade
Longitudinal stop is not parallel Readjust longitudinal stop
Splitting wedge not in adjustment or sewing is too weak Readjust splitting wedge
Height adjustment of the spindle
is stiff
Threaded rod, toothed wheels, slide reals are polluted Clean and lubricate components
Clamping lever is not loosened Check and loosen clamping lever
Milling machine
Machine vibrates Clamping lever for height adjustment is not screwed tightly Tighten clamping lever
Tool is not screwed tightly Tighten tool
Unclean cuts / wood burns Tool is blunt Use sharp tools only
Tool is not installed correctly Check correct installation of the tool
Fast wear and tear of tool Tool is not sharpened correctly Have the tool re-sharpened correctly / install new tool
Covered wood (cement, sand, nails) Use clean wood only
Motor heats up (one can no
longer touch it with bare hands,
it switches off constantly)
Different causes possible Get it checked by an electrician
Machine stops Feed is too fast Reduce feed
Tool is blunt Use sharp tools only
Height adjustment of the spindle
is stiff
Threaded rod, toothed wheels, slide reals are polluted Clean and lubricate components
Clamping lever is not loosened Check and loosen clamping lever
Error search plan
19
DGB
To Next Page
Loading...
