17
• Kinks resulting from incorrect attachment or laying of
the connection cable.
• Cuts resulting from running over the connecting cable.
• Insulation damage resulting from forcefully pulling out
of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely
hazardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains
when checking.
Electrical connection cables must comply with the regula-
tions applicable in your country.
Single-phase motor
• The mains voltage must coincide with the voltage spec-
ified on the motor’s rating plate.
• Extension cables up to a length of 25 m must have a
cross-section of 1.5 mm2, and beyond 25 m at least
2.5 mm2.
• The connection to the mains must be protected with a
16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the
machine and complete repairs on its electrical equip-
ment.
In the event of enquiries please specify the following
data:
• Motor manufacturer
• Type of current of the motor
• Data recorded on the machine’s rating plate
• Data recorded on the switch’s rating plate
If a motor has to be returned, it must always be dis-
patched with the complete driving unit and switch.
EC declaration of conformity
We hereby declare Scheppach Fabrikation von Holzbearbeitungsmaschinen
GmbH, Günzburger Strasse 69, D-89335 Ichenhausen, that the machine
indicated below, on the basis of its design, construction and the version which
we have brought to market, meets the relevant EC requirements stated below.
This declaration is invalid if any changes to the machine are made without our
agreement.
Benificary: Werner Hartmann
Description of the machine
Slide compund Mitre saw
Machine type
MS 305 DB (Art.Nr. 330 0305 901 / 330 0305 902)
Relevant EC directives:
EC machine directive 2006/42/EG,
EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Harmonized European standards applied:
EN 55014-1/A2:2006; EN 61000-3-2/A2:2006; EN 61000-3-11:2000; EN 55014-
2/A1:2001; EN 55014-1:2006; EN 61000-3-2:2006; EN 61000-3-3/A2:2005;
EN 61029-1/A12:2003; EN 61029-2-9:2002; EN 60825-1/A1:2002
Notified body
TÜV Rheinland LGA Products GmbH
Tillystraße 2
D-90431 Nürnberg
Place, Date
Ichenhausen, 02.05.2011
Signature
Werner Hartmann (technical director - Benificary)
To Next Page
Loading...
Need help?
General
