Klarstein 10010174 - Page 14

7. Open the dispenser lid by pressing the lid open button.
8. Lift the dispenser unit (including keg) into the cooling chamber of the dispenser.
9. Attach the end of the dispensing unit to the gas outlet valve.
Attention: Neverllliquidinto
the gas outlet valve.
10. Close the dispenser lid so that it locks with a click.
11.Turnpumpregulatorto„ON“position,youwillhearthevoiceofworkingpump,andthepump
will automatically shut down when the beer barrel pressure is enough.
OFF ON
12. Pull the tap towards you
standing, than you can
taste fresh beer.
Warning: If there is enough pressure in the keg or pressure regulator is closed, the air pump cannot
work, if there is no enough pressure in the beer keg, open the pressure regulator, the air pump will work
automatically.
If you choose the Heineken keg, as it has pressure, must do as follows:
1. Attach the photo, install the supplied adapter on the keg;
will automatically shut down when the beer barrel pressure is enough.
OFF
ON
1. Attach the photo, install the supplied adapter on the keg;
ON
ON
14