Klarstein 10027045 - Loading the Salt into the Softener

Artikelnummer 10027046 (45 cm)
1. Find out about the hardness value of your tap water. Your water utility company will help you.
2. Set value can be found in the water hardness table.
3. Switch on „Power“ switch.
4. Hold down „ Delay“ button and then press „Program“ button for 5 seconds.The buzzer rings one
time and H..  ashes on the digital display (factory setting is H4).
5. To change the setting press „Delay„ button. Each time the button is pressed, the set value in-
creasesby one level. When the value of H7 has been reached, the display jumps back to H0(off).
6. Press „ Program „ button. The chosen setting has now been stored.
Hardness (°dH) Range Value
0-6 soft (1) H0
6-8 soft (1) H1
8-10 medium (2) H2
10-12 medium (2) H3
12-16 hard (3) H4
16-20 hard (3) H5
20-30 very hard (4) H6
30-50 very hard (4) H7
Loading the Salt into the Softener
WARNING
Only use salt speci cally designed for use in dishwashers! All other types of salt not speci -
cally designed for use in a dishwasher, especially table salt, will damage the water softener.
In case of damages caused by the use of unsuitable salt the manufacturer does not give any
warranty nor is liable for any caused damages.
Only  ll with salt just before starting one of the complete washing programmes. This will prevent
any grains of salt or salty water, which may have been split, remaining on the bottom of the machine
for any period of time, which may cause corrosion. After the  rst wash cycle the control panel light
expires. The salt container is located beneath the lower basket and should be  lled as follows:
1. Remove the lower basket and then unscrew and remove the cap from the salt container.
2. If you are  lling the container for the  rst time,  ll 2/3 of its volume with water (around 500ml).
3. Place the end of the funnel (supplied) into the hole and introduce about 2kg of salt.
4. It is normal for a small amount of water to come out of the salt container.
5. Carefully screw the cap back on.
6. Usually, the salt warning light will be off in 2-6 days after the salt container is  lled with salt. The
salt container must be re lled when the salt warning light in the control panel comes on again.
26