EasyManua.ls Logo

Klarstein 10030930 - Page 42

Klarstein 10030930
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
Troubleshooting
Reviewing the charts on the following pages may make you be free of calling for service:
Problem Possible causes What to do
Dishwasher
doesn‘t run
Fuse blown, or the circuit breaker
acted
Replace fuse or reset circuit breaker. Remove any other appli-
ances sharing the same circuit with the dishwasher.
Power supply is not turned on Make sure the dishwasher is turned on and the door is closed
securely. Make sure the power cord is properly plugged into
the wall socket.
Water pressure is low Check that the water supply is connected properly and the
water is turned on.
Drain pump
doesn‘t stop
Overflow The system is designed to detect an overflow. When it does, it
shuts off the circulation pump and turns on the drain pump.
Noise Some audible sounds are normal Sound from detergent cup opening.
Utensils are not secure in the
baskets/ something has dropped
into basket
To ensure everything is secured in the dishwasher.
Motor hums If you do not use it often, remember to set it to fill and pump
out every week, which will help keep the seal moist.
Suds in
the tub
Improper detergent Use only the special dishwasher detergent to avoid
suds. If this occurs, open the dishwasher and let suds
evaporate. Add 1 gallon of cold water to the tub. Close
and latch the dishwasher, then start the „pre-rinse“ wash
cycle to drain out the water... Repeat if necessary.
Spilled rinse agent Always wipe up rinse agent spills immediately.
Stained tub
interior
Detergent with
colorant was used
Make sure that the detergent is the one without colorant
Dishes and
flatware
not clean
Improper program
Improper basket loading
Select a stronger programme
Make sure that the action of the detergent dispenser and spray
arms are not blocked by large dishware
Spots and
filming on
glasses and
flatware
1 Extremely hard water
2 Low temperature
3 Overloading
4 Improper loading
5 Damp powder detergent
6 Empty rinse agentr
7 Incorrect dosage
1 Take out all metal utensils out of the dishwasher.
2 Do not add detergent.
3 Choose the longest cycle.
4 Start the dishwasher and allow it to run for about 18 to 22
minutes, then it will be in the main wash.
5 Open the door to pour 2 cups of white vinegar into the
bottom of the dishwasher.
6 Close the door and let the dishwasher complete the cycle. If
the vinegar does not work use citric acid crystals instead.
Cloudiness
on glassware
Combination of soft water and too
much detergent
Use less detergent if you have soft water and select a
shortest cycle to wash the glassware

Table of Contents

Related product manuals