28
EN
ERROR CODES
Code Description Potential solution
E01 The milk cup or its lid is
not inserted correctly or
the milk cup or its lid is not
removed before self-cleaning.
Check that the milk cup and
its lid are well positioned
and that the milk cup and
its lid are removed before a
self-cleaning cycle.
E02 No water in the water tank
or the lter in the bottom of
the water tank is clogged.
Fill up with water after the
clogging has been rectied.
E03 The lid of the mixing
container is not well positioned.
Position the cover correctly.
E05 Too many ingredients
overload the engine.
Use fewer ingredients, clean
the appliance and try again.
E06 The upper water level
electrode is blocked or there
are too many ingredients in
the appliance.
Clean the electrode or
reduce the amount of food
used.
E07 Abnormal voltage. Make sure that the current
voltage is lower than 160 V
and higher than 260 V. Use
a regulated power supply.
E08 Abnormal communication
between main controller
and driver.
Send the appliance to the
local service department for
repair and maintenance.
E09 Mixing container is missing
or not the correct container
is placed.
Ensure the mixing container
is installed on device. Use
a dry grinding mixing
container for the grinding
function.
To Next Page