12
EN
COMMISSIONING AND OPERATION
Before the rst operation
Before using the machine to prepare coee, run only water (without lter and
coee) during the rst run.
1 Insert the plug into the socket.
2
Fill the jug with cold water. Pull the water tank cover up and pour the
water from the jug into the tank. Replace the water tank cover.
3 Place the jug back in its position.
4 Press the On/O switch to start the cycle.
Coee preparation
1
Fill the water tank. The water level should be below the MAX mark. The
scale on the tank and on the jug indicates the number of cups.
2
Turn the funnel housing to the left, insert a lter and ll it with ground
coee. Use about 6-7 g of medium-ne ground coee per cup.
3 Turn the funnel housing back into the machine.
4 Make sure that the jug is properly seated.
5
Switch on the machine. The power indicator will come on to show that
the machine is on.
6 After the coee is ready, turn the machine o and remove the jug.
7
If the machine is not turned o after making coee, the machine will
automatically turn o after 40 minutes.