19
EN
TROUBLESHOOTING
Failure Possible Reasons Measurement
Not enough heat
or Too heat
Rotate thermostat dial
button improperly.
Correct Thermostat dial
Button in position.
No steam produces Check if the Thermostat
dial has been set towards
the steam range.
Adjust the thermostat dial
as per steam range.
Check if the steam regulator
has been set towards
the steam position.
Set steam regulator
towards the steam range.
Fill water into the box
Leaking water
from Soleplate
Set the thermostat dial
out of steam range.
Set the thermostat dial
as per steam range.
The heat is still not enough. Open steam button only after
the indicator light goes off.
The water is over
than max position
Pour out the remaining water
Little Steam Check if the steam regulator
is in proper location.
Set the steam regulator
to the proper location.
Steam hole or box
is blocked.
Clean hole with
distilled water.
Too little water in the box Fill water into the box
No Spraying No enough pressure
or air inside
Press the spray nozzle
by hand, and push the
spray button several
times continuously.
No or little water in the box Fill water into the box
After the above-mentioned methods to repair iron, if it still cannot come to work
normally, please send to our special repair agent for repair.
To Next Page