Operating Manual CDP3 Page 11 of 40 Version 03
Using the CDP3 in a PAS100
With the Power turned on, turn the Master Volume of the PAS 100 speaker to the second line on the dial.
Start a the loudest part of the CD playing in the CDP3.
Turn up the input knob for either the Upper or Lower Slot until the red Input Overload light begins to flash.
Turn the Input level back down until the light stops flashing and then turn it down one line more. Turn up the Master
Volume until the sound is loud enough.
Note: If the level is set while using a quiet CD, it may be necessary to turn down the Input knob when a loud song is playing.
Check to see if the red Input Overload LED on the PAS100 is flashing. This is always an indication that an Input knob is turned
up too high.
To Next Page
Loading...