SYMBOLS ON PRODUCT
Warning or Caution
Risk of Electrical Shock
Conformité Européenne. Conforms with
European Economic Area directives
WEEE – Battery disposal
Conforms with BCS regulations of
California Energy Commission
Direct Current (DC)
Read Instructions
Recycle
MAINTENANCE
• CLEANING: Disconnect the device from all power sources
and devices prior to cleaning. Use clean, dry, soft, lint-free
cloth to wipe down the entire unit.
DO NOT use abrasive
cleaners or solvents.
• STORAGE: If storing for more than 1 month, charge
completely before storage, and recharge approximately
every 3 months to avoid full discharge. Store in cool
temperatures, mild humidity, and away from direct
sunlight (See GENERAL SPECIFICATIONS). Leaving the
unit in a vehicle or other confined spaces in extreme
hot temperatures can lead to decrease in service life,
overheating, or fire. Extreme cold temperatures below
the specified storage range can also harm performance
and service life. Keep away from corrosive chemicals and
gases. After taking out of storage, inspect visually to make
sure device and all accessories look satisfactory. Allow
unit to return to ambient conditions before recharging or
charging other devices.
• RECHARGING: Recharge as needed. There are no
predesignated intervals at which to recharge as long as you
are using the unit regularly. Avoid discharging completely
on a regular basis, as this can impact overall life. Regularly
inspect ports and charging cable for any debris, dirt,
damage, and corrosion.
DO NOT attempt to x
. Replace
device and/or cable as needed.
OPERATING INSTRUCTIONS
Read these instructions carefully before operating and keep
for future reference.
CHARGING BATTERY
To access the charging port, twist the collar just below the
flashlight head. After charging, please return the collar to
the original position to protect the charging port.
Connect USB-C cable connection to the flashlight; plug
the other end of cable into USB (2.0 or higher) port, or AC
adapter (not included). USB adapter/power supply should
not exceed the specified charging voltage and current
(Max.5.0V DC, min. 0.650A).
•
The battery level indicator will illuminate:
– Solid Green: 100% charge
– Blinking Green: 50-99% charge
– Blinking Yellow: 26-49% charge
– Blinking Red: 16% to 25% charge
– Solid Red: 0% to 15% charge
A full charge could take up to 6 hours, depending on the
charger’s output. Charge completely before using. To
maximize battery life, see MAINTENANCE section (other
side).
NOTE: When charging the flashlight, the unit will not
operate in all modes.
DISCHARGING BATTERY
•
Battery indicator shows for 5 seconds when powered
on.
POWER ON/OFF BUTTON
•
To activate the flashlight, press and release the power
button
5
. The unit will be in HIGH flashlight mode.
•
Hold down the power button to change between modes.
Once the desired mode is on, clicking the power button
will reduce the brightness. This flashlight has white LED
spotlight, white LED area light, and red LEDs.
•
NOTE: If the light is on for more than 5 seconds in ANY
mode, the next press of the power button will shut it off.
This saves the time clicking through modes to power
down.
•
NOTE: The light will turn on in the same mode last used,
when turned off.
MOUNTING OPTIONS
•
The magnet
6
on the endcap can be mounted onto any
ferrous surface.
•
The pocket clip
4
can be removed by unscrewing the
endcap.
•
The holster can be attached to a belt, and the flashlight
stored inside.
TROUBLESHOOTING
•
56413 will NOT recharge IF: The cable is not properly
connected to charger output or battery input. Check
connection.
–
The charging cable is damaged. Replace with
equivalent cable.
–
The charging port or device is not able to supply the
minimum voltage and current for charging. Connect to
appropriate charging source.
ENGLISH
w ww . . co m
information@itm.com1.800.561.8187
To Previous Page
Loading...
Need help?
General
