Klein Tools KLEIN OPENER - Mount #3: Plastic Flat

Mount #3: Plastic Flat
This bracket includes 4 torque washers. Each
torque washer has 4 tiny sharp prongs which are
necessary for mounting and securing the bracket
onto plastic dumpsters.
This mounting
bracket is for plastic
dumpsters with a at
interior wall.
Step 5: For plastic dumpsters mount the bracket 6-12 inches from the back hinge of
the dumpster’s plastic lid depending on how high you want the lid to open. Mounting
closer to the back hinge of the dumpster will raise the lid higher.
Step 7: Tighten 1/2” bolts snug with the ratchet and 3/4” socket until the inside
and outside gaps created by the torque washers are closed and the 4 tiny prongs
on each torque washer has seated into the inner and outer walls of the plastic
dumpster. This allows the torque washers’ prongs to properly pierce the inner
and outer walls of the plastic dumpster, allowing the bracket to securely mount
to the plastic dumpster.
7
5
Mounting Bracket
CLOSE GAP
Dumpster Top Rail
Outside Dumpster
Inside Dumpster
Mount Specic
Instructions
12