Klein Tools KLEIN OPENER - Mount Specific Instructions (Continued); Mount #4: Plastic Lip (Continued)

Mount Specic
Instructions
Step 7: Hold the supporting angle bracket in place (You may need another
person to hold the arm steady while you support the bracket). Tighten the
1/2” bolts snug with the ratchet and 3/4” socket until the inside and outside
gaps created by the torque washers are closed and the 4 tiny prongs on
each torque washer has seated into the inner and outer walls of the plastic
dumpster. This allows the torque washers’ prongs to properly pierce the
inner and outer walls of the plastic dumpster, allowing the bracket to
securely mount to the plastic dumpster.
You DO NOT want to
see a gap between the
dumpster lip and the
bottom of the supporting
angle bracket.
Step 6: The L-shaped supporting angle bracket
needs to rest ush against the bottom of the
outer lip. Make sure to hold the supporting
angle bracket in place while you manually
tighten the bolts.
6
7
CLOSE GAP
Mount #4: Plastic Lip (continued)
14