Scan
The scan function should be preset by the PC programming. (The default setting of S channel is normal operating
channel.)
1. Rotate the channel knob to the S channel and the radio begins scanning. The indicator ashes green during
scanning.
2. To stop scanning, rotate the channel knob to other channel.
Two-Tone (encode & decode)
This function can be preset by the PC programming. With this function, the radio can call corresponding radios.
1. Press and hold PTT, and press programmed key to transmit corresponding 2 Tone code on the channel.
2. A “beep” will be heard when the signal is received. And the indicator ashes until auto reset time ends.
12 www.blackboxradios.com
To Next Page
Loading...