Why is my Klever Kleena K-Bot SX1 cleaning only part of the pool?
If your Klever Kleena Swimming Pool Vacuum is cleaning only a portion of the pool, ensure the power supply is positioned so the cleaner can freely access the entire pool area. Also, check that there's enough slack in the floating cable to allow the cleaner to reach all areas. Finally, clean the filter basket or canister.
Why doesn’t my Klever Kleena K-Bot SX1 Swimming Pool Vacuum climb the walls?
If your Klever Kleena Swimming Pool Vacuum isn't climbing walls, start by cleaning the filter basket or canister. Check the water's chemical levels, as improper levels can cause algae growth, making the walls slippery. Adjust the levels and scrub the walls if needed. Also, ensure there's no debris stuck in the impeller-house or impeller-cover.
What to do if my Klever Kleena K-Bot SX1 is moving in circles?
If your Klever Kleena Swimming Pool Vacuum is moving in circles, try the following: Clean the filter basket or canister. Remove any debris stuck in the impeller-house or impeller-cover. Ensure the power supply is positioned so the cleaner can freely reach all pool areas. Correct the pool and water conditions if algae is present or the water is out of specification.
Why does my Klever Kleena Swimming Pool Vacuum move but not clean the pool?
If your Klever Kleena Swimming Pool Vacuum moves but isn't cleaning the pool, begin by cleaning the filter basket or canister. Additionally, check for and remove any debris stuck in the impeller-house or impeller-cover.
How to troubleshoot a Klever Kleena K-Bot SX1 Swimming Pool Vacuum power supply that is not working?
If the power supply or its switch LED for your Klever Kleena Swimming Pool Vacuum isn't working, first, check that there's voltage in the wall socket. Then, make sure the power supply is plugged in and switched on. Verify the power cable is securely connected into the power supply inlet. If these steps don't resolve the issue, turn the power supply off, wait 30 seconds, and then turn it back on.
What to do if my Klever Kleena K-Bot SX1 Swimming Pool Vacuum doesn’t turn or moves in one direction only?
If your Klever Kleena Swimming Pool Vacuum does not turn or moves in one direction only, remove any debris stuck in the impeller-house or impeller-cover.
Why does my Klever Kleena Swimming Pool Vacuum not move?
If your Klever Kleena Swimming Pool Vacuum isn't moving, check that the floating cable is securely connected to the power supply. Also, inspect the impeller, tracks, and wheels for any obstructions; unplug the power supply first, then open the impeller cover to check for trapped objects, and verify nothing blocks the tracks or wheels.
Important safety warnings regarding the use of the pool cleaner and electrical connections.
Specific water condition limitations and precautions for operating the pool cleaner.
Step-by-step instructions for setting up the pool cleaner before its first use.
Instructions on how to correctly place the pool cleaner into the swimming pool.
Procedure for safely removing the pool cleaner from the pool after operation.
Detailed steps for removing and cleaning the filter basket after each use.
Instructions for performing periodic cleaning of the filter basket panels.
Steps for removing and cleaning the net canister after each cleaning cycle.
Procedure for cleaning debris trapped in the pool cleaner's impeller opening.
General| Type | Robotic Pool Cleaner |
|---|---|
| Power Source | Electric |
| Filter Type | Cartridge |
| Pool Type | In-ground and above-ground pools |
| Cleaning Area | Floor, Walls, Waterline |
| Cleaning Cycle Time | 2.5 hours |
| Filtration | Fine filtration system |
| Brush Type | PVC |
| Cleaning Time | 2.5 hours |
To Next Page
