the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device should be used in such a manner such that
the potential for human contact during normal operation is minimized.
This device has also been evaluated and shown compliant with the IC RF Exposure limits
under mobile exposure conditions. (antennas are greater than 20cm from a person’s body).
for each off mode, standby mode (or another condition which does not exceed the applicable
power consumption requirements for off mode or standby mode) and networked standby into
which the equipment is switched by the power management function or similar function:
— the power consumption expressed in watts rounded to the first decimal place;
— the period after which the equipment reaches automatically standby mode, off mode or
networked standby in minutes and rounded to the nearest minute;
DC OUT 1 ---------USB Type-C(5V/2.0A)
DC OUT 2----------USB Type-A(connect with Flexus Transport 100) ,data
transmission
To Next Page
Loading...
Need help?
General
