When using public roads or paths, the machine must be equipped in accordance
with traffic regulations.
This machine must be tested annually according to UVV guidelines.
A crane book shall be kept.
Work on public roads is prohibited.
Warning signs
Read and observe the operating and safety instructions.
Be careful in the swivel range.
Always keep a sufficient safe distance of 20m from other people.
3. Before first use
Before first use and after a short use, check that all the connections of your fleece
disk are firmly seated. This is important because connections are made during the
first hours of work and screw connections can loosen up under certain
circumstances.
Transport speed shall be reduced in case of poor road surfaces.
Excessive transport speeds cause a very high dynamic load, which shorten the life
of your device.
The hydraulic system is not filled with oil upon leaving the factory. Before first use,
therefore, it must be absolutely ensured that the hydraulic cylinder is
slowly actuated several times in both directions, until the pipe and the cylinders
are filled with oil.
3.1 Intended use
The fleece-winding machine is designed to roll and unroll fleece and films on beets
and other haystacks.
Use in sloping terrain over 5% is not permissible, as there is a risk of tipping over.
4. Operation
4.1 Attachment
The basic configuration of the device provides for its attachment to the rear
hydraulics of a tractor, which must have at least 150 hp and an empty weight of
8500 kg. In matching coupler parts, it must be ensured that unintentional loosening
of the connection is avoided, especially in fast couplers. Fastening of the
connection to the tractor ensures more security and ease of use. Side braces must
be rigid and the air pressure in the rear tires in the upper limit approved by the
manufacturer to prevent machine oscillation.
The slewing ring must be mounted horizontally.
To Next Page
Loading...